This post may contain affiliate links. Read my Disclosure Policy to learn more.

Last year I was working full steam on a SWAP2017 wardrobe. You can read some of the previous SWAP2017 posts here <link here>:

For one of my uppers – I opted for a  knitted item. The inspiration was based on a Bella Freud 1970 Jumper . This jumper retails at £300.

The pattern I used was the Holsten jumper by Anstrick

Once I had selected the pattern the next challenge was finding the bright red yarn colour. Someone on Ravelry recommended Cascade Ultra Pima Cotton DK yarn. The yarn has a lovely lustre to it and it had a lipstick red shade that looked promising. I ordered several balls of different reds from various brands but this was the one that nailed it. Luckily they also had the black and white of the same yarn.

The next challenge was how to prevent bleeding. From the many posts that I read where people had knitted with red and white or black and white – there was a bleeding issue when the garment was washed. After ruminating on the issue for a while I thought that maybe I could try pre-washing the yarn before knitting to reduce any bleeding potential in the same way we prewash fabric for sewing.

Luckily the yarn comes in skeins. My first attempt was a bit of a travesty because I didnt do anything to prevent the yarn from tangling. On my second attempt, I loosely tied the skein at 4 different points so that I could easily reconstitute the skein.

The prewashing process involved filling the sink with hot water and soaking for about an hour, gently wringing the water out and repeating until the water ran clear. For the red this took approximately 4 soakings, the black took 6 soakings to run clear. I also did the white twice because I needed it to have a similar texture to the black and red.

After drying out the skeins I then had to wind them into yarn balls. There were a lot of online tutorials to help. I used a kitchen roll tube and spent several hours balling up the skein. It was tedious but I think it was worth it in the end. 

Dryng the prewashed yarn

Pre washed and un washed side by side

Prewashed on left. Has a ‘fuller’ look and feel. Unwashed on right.

 

I swatched with 3.75, then 3,5 but it was 3,25 that got the correct stitch gauge. I should have done some mods since the pattern calls for fingering 4 ply but my yarn was DK. However, I still do not understand these things so I went on ahead with the proviso that I would be trying it along the way to see what I need to change. On the whole this worked, I think I managed to get away with it :-).

This pattern knits up quite quick since it all stokinette stitch. It was also a great opportunity for me improve my Portuguese knitting skills. I think the fit is quite good. Yarn feels comfy against my skin.

The prewashing seems to have worked. When I washed this there was no bleeding.

And here I am wearing it last year.

The pattern instructions were very clear and well written. I learnt some new techniques like the saddle stitch for the raglan sleeve. It may not be the best but I had a great time knitting this. I’d have liked to do add in a HILA motif on the white section but my skills are not yet there. I am still very happy with this jumper.

Finally, I used just under 5 skeins of red and less than 1 skein each of black and white. The total cost of the yarn was £50.48. Not bad considering the inspiration retails at £300. Win!

Thanks for stopping by my little corner of the internets. Until next time, happy knitting!

Peace and love,

Hila

 

 

 

 

 

 

 

 

Thanks for stopping by this corner of the interwebs.

Peace and love,

Hila